| |
TM 11-5821-333-12
3-3. LOADING FILL DEVICE FROM ANOTHER FILL DEVICE. Continued
ACTION
RESPONSE
I
h. Repeat steps d through g for each position
to be filled.
i. Set fill device function switch to OFF and
disconnect fill devices.
j. Check the fill data using the procedure in
paragraph 2-18.
3-4. LOADING AND CLEARING FH SYNC TIME.
A time variable is needed by all RTs in a net to synchronize FH communications. The following is the procedure
for loading FH sync time using the radio set keyboard,
Normally only the NCS will load FH sync time into the radio set.
a. Setting FH Sync Time (Keyboard):
(1). Obtain nets time standard; then set FCTN to LD.
(2). Load
(a).
(b) .
(c) .
(d) .
(3). Load
(a).
(b) .
(c).
(d) .
and store days (last two digits of Julian date, page A-2):
Press TIME (display will show current days).
Press CLR (display will show two lines).
Load new days (press number buttons for new days,
display will show new days).
Store new days (press STO (Sto/ENT) button, display will
blink and show new days).
and Store Hours and Minutes:
Press TIME twice (display will show current
hours and minutes).
Press CLR (display will show four lines).
Load new hours and minutes (press number buttons
for new hours and minutes). Display stays on for
approximately 62 seconds, or until STO (Sto/ENT) is
pressed in step (d).
Store
hours
hours and minutes (press STO (Sto) button to store
and minutes and to reset seconds); display blinks.
3-3
|