|
| TM 11-5821-260-34P-1
SECTION I
INTRODUCTION
1. Scope
entered in the first and second positions of the
Uniform SMR Code format as follows:
This manual lists spares and repair parts; special
Definition
code
tools; special test, measurement, and diagnostic
PA--Item procured and stocked for anticipated or
equipment (TMDE), and other special support equip-
known usage.
ment required for performance of direct support and
K.F-An item of a maintenance kit and not purchased
general support maintenance of the AN/ARC-
separately. Maintenance kit defined as a kit that
115A(V)1. It authorizes the requisitioning and issue
provides an item that can be replaced at organiza-
of spares and repair parts as indicated by the source
tional or intermediate levels of maintenance.
and maintenance codes.
AH-Item to be assembled at general support main-
tenance level.
2 General
XA-Item is not procured or stocked because the
requirement for the item will result in the replace
This Repair Parts and Special Tools List is divided
ment of the next higher assembly.
into the following sections:
XD-A support item that is not stocked. When
a. Section II. Repair Parts Lists. A list of spares
required, item will be procured through normal
and repair parts authorized for use in the perfor-
supply channels.
mance of maintenance. The list also includes parts
NOTE
which must be removed for replacement of the
Cannibalization or salvage may be used as a
authorized parts. Parts lists are composed of func-
source of supply for any items source coded
tional groups in numeric sequence, with the parts in
above except those coded XA and aircraft
each group listed in figure and item number
support items as restricted by AR 700-42.
sequence.
b. Section III. Special Tools List. Not applicable.
c. Section IV. National Stock Number and Part
(2) Maintenance code. Maintenance codes are
Number Index. A list, in National item identification
assigned to indicate the levels of maintenance autho-
number (NIIN) sequence, of all National stock num-
rized to USE and REPAIR support items. The
bers (NSN) appearing in the listings, followed by a
maintenance codes are entered in the third and fourth
list, in alphameric sequence, of all part numbers
positions of the Uniform SMR Code format as follows:
appearing in the listings. National stock numbers and
(a) The maintenance code entered in the third
part numbers are cross-referenced to each illustration
position will indicate the lowest maintenance level
figure and item number appearance.
authorized to remove, replace, and use the support
item. The maintenance code entered in the third
position will indicate one of the following levels of
3. Explanation of Columns
maintenance:
a. Illustration. This column is divided as follows:
Code
Application/Explanation
(1) Figure number. Indicates the figure number
O-Support item is removed, replaced, used at the
of the illustration on which the item is shown.
organizational level.
(2) Item number. The number used to identify
F-Support item is removed, replaced, used at the
item called out in the illustration.
direct support level.
b. Source, Maintenance, and Recoverability
H-Support item is removed, replaced, used at the
(SMR) Codes.
general support level.
(1) Source code. Source codes indicate the man-
D-Support items that are removed, replaced, used
ner of acquiring support items for maintenance,
at depot, mobile depot, specialized repair activity
repair, or overhaul of end items. Source codes are
only.
1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |