Click here to make tpub.com your Home Page

Page Title: INITIAL CONTROL SETTINGS
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



TM 11-5820-917-13
MINUTES switch.  The sweep is inhibited for the 5-minute period when the MINUTES
switch is in the O position.  At the end of each clock hour (end of the 55th minute
sweep interval), the cycle automatically repeats.
3-7. INITIAL CONTROL SETTINGS. Before turning power on, open small front panel
control door, and make the following preliminary control settings:
WARNING
Make sure that the RCS-4B frame is grounded by the three-wire, three-
prong power cord or a separate ground strap before operating. If not
grounded the RCS-4B frame and exterior panel could be at a potentially
dangerous voltage level.
a.  Make sure that BATT switch is OFF.  The only time that the BATT switch
should be on is when the receiver is on and synchronized with a transmitter. Also,
the BATT switch must be ON during receiver test.
b.  Make sure AC line voltage select switch and fuse on 4028 unit are matched
to the local AC line power.
c.
Set INPUT ATTEN (dB) switch to 0.
d.  Set ANTENNA SELECT thumbwheel switches to the appropriate antenna input
jack number (1, 2 or 3) for each path.  Each transmitter received by the RCS-4B
is assigned a path number (1, 2 or 3).  Each path may have a separate receive antenna
or different paths may share an antenna.  Assignment of path to receiver antenna
inputs may be done in any order or in any combination.  For example, path 1 may use
antenna 1(J1); paths 2 and 3 may use antenna 2(J2), and antenna 3(J3) may not be
used at all; or all paths may use the same antenna.  If all paths require the same
antenna, input J1 is normally used, but inputs J2 and J 3 will work equally well.
Make sure antenna(s) are connected to the 6043 power divider or directly to the
4028 as required.
e. Place FREQ switch in either 2-16 or 2-30 position depending on the selected
frequency sweep limit that corresponds with the transmitter setting.  One switch
determines the sweep limit for all three paths.
3-8. START UP PROCEDURE.  The pre-operative start-up procedure for the
receiver is performed as follows:
a.  Press POWER switch to on (lighted) position. Timer and sweep may start
immediately.
b.  Check that indicator lamps are good by pressing LAMP TEST switch. With
switch depressed indicators and digital display should light.
c.
With MODE switch to MAN, press RESET pushbutton to set sweep to 02.00 MHz.
d.  Turn MODE switch to SET 1 and press RESET.  Then press START and RESET
again.  Repeat for SET 2 and SET 3.  All path clocks are now at OO:OO system time.


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business