|
| |
TM 11-5820-890-30-5
15-19. VISUAL INSPECTION OF BATTERY TRAY SUBASSEMBLY
Tools:
Flat tip screwdriver
(12A1).
ITEM
ACTION
REMARKS
a. Battery tray assembly
Set upside down on work surface with
left side toward you. See figure 15-4.
b. Eight captive screws (4)
Use flat tip screwdriver. Fully loosen
and flat washers (5)
and inspect eight captive screws and
flat washers securing mounting plate
assembly (2) to battery tray subas-
sembly (1). If damaged, obtain
replacement.
Remove and inspect for damage.
If damaged, obtain replacement.
Inspect for cuts, tears, and improper
seating. If defective, obtain replacement.
Set upside down on work surface with left
c. Mounting plate
assembly (2)
d. Battery tray gasket (3)
e. Battery tray
subassembly (1)
f. Wires
Steps f through r refer to
replacement procedures
for items on battery tray
subassembly (see figure
15-5). Perform only pro-
cedures for defective items.
side toward you. See figures 15-4 and 15-5.
Inspect for frays, faulty connections, and
If defective, proceed to
other obvious defects. See figure 15-6.
paragraph 15-29.
Figure 15-4. Battery Tray Subassembly (Front, Bottom, and Right Side Views)
With Mounting Plate Assembly.
15-20
|
