|
| |
TM 11-5820-890-30-5
8-24. REPLACEMENT OF BATTERY BOX CASE. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
q.
P1 connector (6)
Use cross tip screwdriver. Position connec-
tor to case. Install four retained screws
(9), Iockwashers (8), and flat washers (7)
securing connector to case.
r. Terminal lug (17)
s. J1 connector (34)
t.
u.
v.
w.
x.
y.
Use cross tip screwdriver. Position termi-
nal lug to case. Install retained screw (9),
Iockwasher (8), and flat washer (7) secur-
ing terminal lug to case.
Install.
Two-wire transient
Use soldering kit. Position and solder
protection CCA (26)
three tagged wires to terminals E1 thru
E3.
Access cover (27)
Use torque screwdriver. Install and tighten
five captive screws (31) securing access
cover to case. Torque screws to 5 in-lb.
Catch assemblies (18)
Install.
Strikes (23) and (14)
Use cross tip screwdriver. Position retain-
ed strikes to case. Install four retained
screws (11), Iockwashers (12), and flat
washers (13) securing Strikes to case.
Battery box cover (1)
Position on case.
Two battery box cover
Fasten two twist lock latches securing bat-
NOTE
Ensure single keyway is
located to right of raised
letters.
These were removed in
step i.
Refer to paragraph 8-18
installation instructions.
NOTE
for
Before and after soldering,
clean wires and terminals
with alcohol and cotton
swabs.
This was removed in
step g.
Refer to paragraph 8-14
installation instructions.
These were removed in
step b.
This was removed in
step c.
latches (32)
tery box cover (1) to battery box case (15).
Section V. PREPARATION FOR STORAGE OR SHIPMENT
for
8-25. GENERAL INFORMATION.
Pack the battery box in an approved shipping container.
8-21
|
