|
| |
TM 11-5820-890-30-5
8-24. REPLACEMENT OF BATTERY BOX CASE. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
b. Strikes (23) and (14)
Use cross tip screwdriver. Remove and
retain two screws (11), flat washers (13),
and Iockwashers (12) securing each strike
to battery box case (15).
c. Battery box cover (1)
Remove and retain.
d. Catch assemblies (18)
Remove and retain.
e. Access cover (27)
Use flat tip screwdriver. Fully loosen five
captive screws (31). Remove cover to al-
low for resoldering.
f. Two-wire transient
protection CCA (26)
g. Access cover (27)
h. J1 connector (34)
i.
Terminal lug (17)
j.
P1 connector (6)
k. Two seal screws (16)
l.
Plastic strip (10)
m. Battery box case (15)
INSTALLATION
n. Battery box case (15)
o. Plastic strip (10)
p. Two seal screws (16)
Use soldering kit. Tag and desolder three
wires from terminals E1 thru E3.
Remove and retain.
Remove and retain.
Use cross tip screwdriver. Remove and
retain screw (9), Iockwasher (8), and flat
washer (7) securing terminal lug to bat-
tery box case (15).
Use cross tip screwdriver. Remove and
retain four screws (9), Iockwashers (8),
and flat washers (7) securing P1 connector
to case. Remove and retain P1 connector
with all wires attached.
Remove and retain.
Remove and retain.
Discard.
Obtain replacement.
Install.
Install.
Refer to paragraph 8-14 for
removal instructions.
Refer to paragraph 8-18 for
removal instructions.
Refer to paragraph 8-20 for
removal instructions.
Refer to paragraph 8-23 for
removal instructions.
Refer to paragraph 8-23 for
installation instructions.
Refer to paragraph 8-20 for
installation instructions.
8-20
|
