|
| |
TM 11-5820-890-30-5
8-19. REPLACEMENT OF P1 CONNECTOR.
Tools:
Cross tip screwdriver
Soldering kit
Soldering aid
Heat sink
Expendable Supplies:
Cotton swabs
Solder
Alcohol
ITEM
ACTION
REMARKS
b. Wires
c. P1 connector (6) and
gasket (5)
REMOVAL
a. Battery box case (15)
Use cross tip screwdriver. Remove and
retain four screws (9), Iockwashers (8),
and flat washers (7) securing P1 connec-
tor (6) to case. Pull P1 from case.
Slide insulation sleeving away from solder
joints. Use soldering kit. Tag and desolder
wires from P1 connector.
Remove P1 connector and gasket from
case. Inspect gasket and obtain replace-
ment if required. Discard P1 connector.
INSTALLATION
d. P1 connector (6) and
gasket (5)
e. Wires
Obtain replacement and position to gasket.
Use soldering kit. Position and solder
tagged wires to P1 connector. Replace
insulation sleeving over solder joints.
f.
Battery box case (15)
Position P1 connector to case. Use
cross tip screwdriver. Install four re-
tained screws (9), Iockwashers (8),
and flat washers (7) securing P1 con-
nector to battery box case (15).
8-20. REPLACEMENT OF SEAL SCREW.
Tools:
Flat tip screwdriver
Torque screwdriver
NOTE
Before and after soldering,
clean wires and solder
joints with alcohol and
cotton swabs.
NOTE
Ensure single keyway is to
right of raised letters.
ITEM
ACTION
REMARKS
REMOVAL
a. Battery box case (15)
Use flat tip screwdriver. Remove
defective seal screw (16) from
battery box case (15). See figure 8-3.
b. Seal screw (16)
Discard.
8-16
|
