|
| |
TM 11-5820-890-30-5
7-17. REPLACEMENT OF FILTER EMI-CCA. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
h. FILTER EMI-CCA wire
Use soldering kit. Solder wires to correct
terminals of FILTER EMI-CCA.
i.
Screw (19) and
Use cross tip screwdriver. Install and
Iockwasher (18)
hand tighten screw (19) and Iockwasher
(18) securing terminal lug (17) to FILTER
EMI-CCA.
NOTE
Before and after soldering,
clean wires and terminals
with alcohol and cotton
swabs.
j.
Eight screws (5)
Use cross tip screwdriver. Install and
and Iockwashers (6)
hand tighten eight screws (5) and
Iockwashers (6) securing access
cover (1) to connector case (12).
Use torque screwdriver. Torque
screws to 8 to 10 in-lb.
If a screw is not stripped
but will not tighten, refer
to paragraph 7-16 for
replacement of its threaded
screw insert (if present).
If a tapped hole is defec-
tive, refer to paragraph
7-10 for replacement of
the connector case (12).
Section V. PREPARATION FOR STORAGE OR SHIPMENT
7-18. GENERAL INFORMATION.
Pack the electrical connector assembly (13A1) in an approved shipping container.
7-22
|
