| |
TM 11-5820-890-30-5
7-17. REPLACEMENT OF FILTER EMI-CCA.
Tools:
Cross tip screwdriver
Soldering kit
Expendable supplies:
Solder
Alcohol
References:
Paragraph
Paragraph
Cotton swabs
7-10 for removal and installation of connector case.
7-16 for removal and installation of threaded screw inserts.
ITEM
ACTION
REMARKS
REMOVAL
a. Eight screws (5) and
Use cross tip screwdriver. Remove and
Inspect each screw and its
Iockwashers (6)
inspect eight screws (5) and lockwash-
threaded screw insert (if
ers (6) securing access cover (1) to
present) to determine if
connector case (12). If damaged,
any is defective. If a screw
obtain replacement. Lay access cover
is stripped, do not replace
to one side. See figure 7-2.
its threaded screw insert.
If the holes are tapped,
there will be no threaded
screw insert.
b. Screw (19) and
Iockwasher (18)
c. FILTER EMI-CCA wires
d. Two screws (25),
flat washers (24), and
Iockwashers (23)
e. FILTER EMI-CCA
INSTALLATION
f. FILTER EMI-CCA
g. Two screws (25),
flat washers (24), and
Iockwashers (23)
Use cross tip screwdriver. Remove and
inspect screw (19) and Iockwasher (18)
securing terminal lug (17) to FILTER EMl-
CCA. If damaged, obtain replacement.
Record location of wires soldered to
E1 and E2 of FILTER EMI-CCA.
Use soldering kit. Desolder each wire.
Use cross tip screwdriver. Remove and
inspect two screws (25), flat washers
(24), and Iockwashers (23) securing
FILTER EMI-CCA to connector case (12).
If damaged, obtain replacement.
Remove and discard.
Obtain replacement FILTER EMI-CCA
and place in connector case (12).
Use cross tip screwdriver. Install and
hand tighten two screws (25), flat washers
(24), and Iockwashers (23) securing
FILTER EMI-CCA to connector case (12).
7-21
|