|
| |
TM 11-5820-890-30-5
4-61. REPLACEMENT OF AUDIO AMPLIFIER CHASSIS O-RING GASKET. Continued
ITEM
ACTION
REMARKS
INSTALLATION
j.
O-ring gasket (2)
k. Wires
Install in channel on audio amplifier
chassis case and secure with
cyanoacrylate adhesive.
Using soldering kit, solder tagged wires
into appropriate position. Remove wire
tags.
Apply silicone compound
to o-ring gasket before
installation.
Before and after soldering,
clean wires and terminals
with alcohol and cotton
swabs.
l.
Connector J9 (8)
Install retained connector J9 (8)
on audio amplifier chassis (2).
m. Transistor Q1 (3)
Install retained transistor Q1 (3)
on audio amplifier chassis (2).
n. Bottom shelf (9)
Position audio amplifier chassis (8) on
bottom shelf so screw holes are aligned.
Using cross tip screwdriver, install three
retained screws (3) and flat washers
securing bottom shelf (9) to audio
amplifier chassis (8).
o. Four screws (4 and 5)
p. Screws (2)
q. Screws (1)
and flat washer
r.
1 - Watt audio amplifier
CCA (4)
Using cross tip screwdriver, install four
retained screws (4 and 5) securing top
shelf (10) to audio amplifier chassis (8).
Using flat tip screwdriver, install retained
screw (2) securing power supply chassis
(7) to audio amplifier chassis (8).
Using cross tip screwdriver, install retained
screw (1) and flat washer securing power
supply chassis (7) to audio amplifier
chassis (8).
Install retained 1 - Watt audio amplifier
CCA (4). See figure 4-14.
See figure 4-150
Refer to paragraph 4-54 for
installation procedures.
Refer to paragraph 4-53 for
installation procedures.
See figure 4-17.
These were removed in
step d.
These were removed in
step e.
This was removed in
step c.
These were removed in
step b.
Refer to paragraph 4-52 for
installation procedures.
4-174
|
