|
| |
TM 11-5820-890-30-5
4-39. REPLACEMENT OF POWER CONTROL CHASSIS O-RING GASKET. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
p. Connector P1 (12)
Using flat tip screwdriver, install four
retained screws (14) securing connector
P1 to power supply chassis (6). Move
connector P1 aside.
q. Bottom cover (13)
Install.
r. Two screws (5)
s. Five screws (7 and 8)
t.
Two screws (1) and
flat washers (2)
u. Terminal lugs (30)
Six captive
v.
screws (13) and rear
access cover (12)
Using cross tip screwdriver, install two
retained screws (5) securing side panel
(6) of power control chassis (4) to power
supply chassis (15).
Using cross tip screwdriver, install five
retained screws (7 and 8) securing top
shelf (9) to mounting rail (10) on side
panel (6) of power control chassis (4).
Using cross tip screwdriver, install two
retained screws (1) and flat washers (2)
securing bottom shelf (3) to power control
chassis (4).
Using cross tip screwdriver, install retained
screw (29) and Iockwasher (23) securing
terminal lugs (30) to electrical post (27).
Hold in place and tighten six captive
screws (13) securing rear access cover
(12) to power control chassis (11).
Using torque screwdriver, torque
screws to 8 to 10 in-lb.
These were removed in
step h. See figure 4-13.
See figure 4-10.
Refer to paragraph 4-40 for
removal procedures.
See figure 4-11.
These were removed in
step f.
See figure 4-11.
These were removed in
step e.
See figure 4-11.
These were removed in
step d.
See figure 4-10.
These were removed in
step c.
See figure 4-5.
This was removed in
step b.
—
4-140
|
