|
| |
TM 11-5820-890-30-5
4-9.
OPERATIONAL CHECK. Continued
The operational check is divided into steps. Each step verifies a particular function. Follow the instruction in the
“Action” column. Check the response. If the response is correct, proceed with the next lettered step. When a
Step has been completed, proceed with the next Step. A "No response" in the "Response" column means that
any response is not of interest.
The switch settings for the test equipment are given in the “EQUIPMENT PRESETS” section of the test setup
figure. Set the test equipment switches to the indicated presets and then verify the settings. If a test response is
incorrect, check the equipment settings and the test adapter cabling before going to a troubleshooting chart or
replacing a bad module.
High voltage (200 V dc) is present at mounting adapter connector J1. The large current capacity
of the test power supply can cause personal injury. Use caution when connecting the test setup
and taking measurements to avoid personal injury.
Connect equipment as shown in figure 4-2 to perform the operational check of the mounting adapter.
4-5
|
