|
| |
TM 11-5820-890-30-5
Section II. REPAIR PARTS, SPECIAL TOOLS, TMDE,
AND SUPPORT EQUIPMENT
Subject
Para
Page
Common Tools and Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5
4-4
Special Tools, TMDE, and Support Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6
4-4
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
4-4
4-5.
COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
4-6.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
For the TMDE and support equipment required for DS, seethe maintenance allocation chart. It is Appendix Bin
TM 11-5820-890-20-2.
4-7.
REPAIR PARTS.
Repair parts are listed and illustrated in the repair parts and special tools list (TM 11-5820-890-30P-3) covering
Direct Support maintenance for this equipment.
Section III. TROUBLESHOOTING PROCEDURES
Subject
Para
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
Operational Check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-10
Test Precautions and Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-11
Explanation of Symbols and Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-12
Troubleshooting Flowcharts.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-13
Page
4-4
4-4
4-13
4-13
4-14
4-15
4-8.
GENERAL.
This section provides the troubleshooting procedures used to isolate a defective mounting adapter. The
troubleshooting information is presented in the form of flowcharts. They systematically get from a symptom to
the bad module.
4-9.
OPERATIONAL CHECK.
The operational check provides a step-by-step procedure for evaluating amounting adapter. If the operational
check is passed, the mounting adapter can be returned to service. If it does not pass the test, the bad module or
the troubleshooting chart to be used will be identified. The troubleshooting procedures are in paragraph 4-10.
4-4
|
