|
| |
TM 11-5820-890-30-5
3-26. REPLACEMENT OF CONNECTORS. Continued
c. Replacement of Six-pin Audio Connectors (J13, J14, and J18).
ITEM
ACTION
REMARKS
REMOVAL
a. Spanner nut (7A)
Using 3/4-inch spanner wrench, remove
See figure 3-12 (sheet 1).
and retain spanner nut from audio con-
nector (7), Remove connector from
test adapter.
b. Wires and pins
c. Connector (7)
INSTALLATION
d. Wires and pins
e. Connector (7)
f.
Spanner nut (7A)
Using soldering kit, desolder wires from
pins on connector. Note positions of
wires connected to audio connector.
Discard.
Using soldering kit, solder wires to correct
Before and after soldering,
pins on connector.
clean solder joints with
cotton swabs and alcohol.
Insert replacement connector in test
adapter with correct orientation.
Using 3/4-inch spanner wrench, install
and tighten spanner nut on connector.
This was removed in
step a.
3-95
|
