Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: REPLACEMENT OF EXCITER/POWER AMPLIFIER (1A11). Continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 



TM 11-5820-890-30-5 2-44.  REPLACEMENT  OF  EXCITER/POWER  AMPLIFIER  (1A11).  Continued ITEM ACTION REMARKS REMOVAL Continued e.   Exciter/power   amplifier INSTALLATION f.   Exciter/power   amplifier g.   Four   screws h.  RF  cables  (1W1,  1W2, and 1W5) i.                     RT   bottom   cover Push  from  bottom  and  remove  exciter/ power   amplifier. Check  connector  location  and  install. Press  down  to  fully  seat  connector. Thread  and  tighten  four  retained  screws. Use  torque  screwdriver.  Torque  screws  to 8  to  10  in-lb. Attach   to   exciter/power   amplifier. Install. j.                RT  top  cover Install. 2-45.  REPLACEMENT  OF  RF  CABLES  1W1  THROUGH  1W5. Tools: Diagonal  cutting  pliers Flat  tip  screwdriver Round  nose  pliers Torque   screwdriver References: Paragraph  2-35  for  removal  and  installation  of  RT  covers. Figure  2-17  for  location  of  RF  cables. See  figure  2-16  for  location of  access  opening. See  figure  2-16  for  screw locations. See  figure  2-17  for  cable locations. Refer  to  paragraph  2-35 for  installation  of  bottom cover. Refer  to  paragraph  2-35  for installation  of  top  cover. ITEM ACTION REMARKS REMOVAL a.   RT   bottom   cover Remove. Refer  to  paragraph  2-35  for removal  of  bottom  cover. b.   Cable   ties Use  diagonal  cutting  pliers.  Cut  any  cable ties  securing  the  RF  cable. c.   RF   cable Use  round  nose  pliers.  Locate  proper  cable  See  figure  2-17  for  cable and  pull  to  disconnect  at  each  end. location. INSTALLATION d.   RF   cable Use  round  nose  pliers.  Push  each  end  of See  figure  2-17  for  cable new  cable  onto  its  connector. location. e.   RF   cable If  necessary,  secure  with  new  cable  tie. Trim  excess  off  the  cable  tie. 2-170


Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business