|
| |
TM 11-5820-890-30-5
2-35. REPLACEMENT OF RT COVERS. Continued
b.
Removal and Installation of Bottom Cover.
Tools:
Flat tip screwdriver
Torque screwdriver
ITEM
ACTION
REMARKS
REMOVAL
a. RT
b. 13 captive
screws
c. Bottom cover
INSTALLATION
d. Bottom cover
Place on work surface with bottom
side up.
Use flat tip screwdriver. Fully loosen.
Lift free from RT.
Set in place on RT.
e. 13 captive
Thread and tighten. Use torque screw-
screws
driver. Torque screws to 8 to 10 in-lb.
2-36. REPLACEMENT OF MODULES 1A2, 1A6, 1A7, 1A12, 1A13, 1A14, and 1A15.
This procedure is for replacement of the following modules.
Remote I/O Module (1A2)
Two-Wire Interface (1A6)
Switching Module (1A7)
Audio Power Supply (1A12)
Audio Control Module (1A13)
Audio Data I/O Module (1A14)
Data Rate Adapter (1A15)
Figure 2-15 shows the locations of these modules.
Tools:
Flat tip screwdriver
Module extractor
Torque screwdriver
References:
Paragraph 2-35a for removal and installation of top cover.
Paragraph 2-34.a for use of module extractor.
ITEM
ACTION
REMARKS
REMOVAL
a. Top cover
b. Module
c. Module
Remove.
Hook module extractor to module.
Pull free of RT.
Refer to paragraph 2-35 for
removal of top cover.
Refer to paragraph 2-34 for
use of module extractor.
2-160
|
