Figure 3-5. Radio patch panel (p/o 1A15).front interior view, parts location

TM 11-5820-695-35

Figure 3-5. Radio patch panel (p/o 1A15).front interior view, parts location

(1) Removal.

(i) Release the meter panel assembly 1A15A8

(a) Using fingernail slots on sides of lens

and position it downward until it rests against electrical

assembly, pull lens assembly out approximately 5/8" (A,

equipment cabinet 1A16.

(j) Remove the housing from meter panel

(b) Rotate lens assembly 90

assembly 1A15A8.

(2) Replacement.

release tension on index keys, then pull complete lens

assembly out (D, fig. 3-8).

(a) Repeat steps (1)(a) through (d) on

replacement indicator light assembly.

(d) Unscrew two screws (C, fig. 3-8) until the

captive nuts reach rear of their travel range releasing

(b) Remove

cover

from

housing

housing from cover.

replacement indicator light assembly (T, fig.6-8).

(e) Loosen the two meter panel captive screws

meter panel assembly 1A15A8, and position the meter

panel assembly 1A15A8 in. a horizontal position.

(f) Swing the meter panel in an upright position

and lock it in position with 'the panel locking latch (fig. 3-

(d) Slip cover over housing from rear of meter

4).

panel assembly lA15A8 until cover and housing fit snug

against 1A15A8 (D, fig. 3-8).

(g) Tag, unsolder, and remove the wires

connected to the indicator light assembly terminals.

(e) Solder wires removed in step (1)(g) to

terminals on rear of indicator light assembly.

(h) Slide the cover off the housing and away

from the rear of the panel (view D, fig.3-8).

3-36