INSTALLATION - TM-11-5820-670-300323

TM 11-5820-670-30

2-79. VOLUME CONTROL SWITCH R 9103 REPLACEMENT. (CONT)

NOTE

Discard attached resistor along with defective switch.

INSTALLATION

NOTE

Before attempting to install switch in control panel, a specified value resistor must be

soldered between terminals as shown in detail A.

Insulation must be installed on both wire leads of resistor prior to soldering (step 1).

1. Install insulation (10) on both wire leads of resistor (11) as shown in detail B.

2. Solder both wire leads of resistor (11) as shown in detail A.

3. Solder one white and white wire (9), one white and brown wire (8), and one black wire (7) to

switch (5).

NOTE

When performing next step ensure locating tab on switch is in locating hole behind

control panel.

4. Position switch (5) in control panel (6) and install IT Iockwasher (4) and nut (3) and, using

wrench, tighten nut (3).

5. Install cover (2) and, using screwdriver, tighten two turn-lock fasteners (1).

FOLLOW-ON MAINTENANCE: Install light panel (para 2-76).

2-231