Section II. INSTALLATION - TM-11-5820-554-120063

TM 11-5820-554-12

ELOD0025

Figure 9-1. Regulator, Voltage CN-1214/G ,front panel view.

Section II. INSTALLATION

that will provide adequate ventilation, and connecting

9-5. Tools and Equipment Required for

the input and output cables. Perform the operations

Installation

listed below.

CAUTION

The tools and equipment required for installation of

Provide ventilation for the unit to insure

Regulator, Voltage CN-1214/G are listed below.

adequate heat dissipation.

Avoid

a. Tools. Tool Kit, Electronic Equipment

installing the unit close to heat-producing

TK101/G.

equipment such as space heaters.

b. Test Equipment. Multimeter AN/USM-223.

a. Hoist the regulator out of the shipping carton,

and lower it onto a bench; use a chain hoist attached to

9-6. Installation Procedure

the four eyebolts on the top.

b. Locate the regulator on the bench in accordance

The installation of Regulator, Voltage CN-1214/G

with minimum clearances (fig. 9-2)

consists only of removal of the equipment from the

c. Complete all external connections (A, fig. 9 3).

shipping box and hoisting it into a position on a bench

9-7. Controls and Indicators (fig. 9-3)

Control

Function

Circuit breaker ............................................................................................... Used to turn unit on and off; provides overload protection.

OUTPUT VOLTAGE control ........................................................................ Used to set the desired output voltage.

LINE pilot light (amber) ................................................................................ Indicates when unit is energized

CONTROL circuit fuse.................................................................................... Control circuit protection.

9-2