|
| TM 11-5820-401-34-3/0967-LP-432-3060
6-5. A1000 ASSEMBLY MAIN CIRCUIT BOARD VR1001 REPLACEMENT. (CONT)
INSTALLATION
EL4GQ065
NOTE
Step 1 is for A-model only. If plain model, proceed to step 2.
1. Put end of Voltage Regulator wiring harness (1) through hole in Circuit Board
VR1001 (2).
CAUTION
To prevent breaking ground wire (3), move out of way before installing Circuit Board
VR1001 (2).
2. Position Circuit Board VR1001 (2) in case (4) and install five small screws (5) and one large
screw (6).
3. Install ground lugs (7) and two small screws (8).
NOTE
Note positioning of ground lugs (7).
4. Using small screwdriver, carefully tighten eight screws (5), (6), and (8).
6-11
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |