Click here to make tpub.com your Home Page

Page Title: CONTROL AND SWITCH SETTINGS
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



TM 11-5820-401-34-3/0967-LP-432-3060
AUDIO AND SQUELCH PREAMPLIFIER A4300 ALINEMENT. (CONT)
5-21 .
INITIAL EQUIPMENT CONTROL SETTINGS. Set equipment controls as indicated in the following
table. When using alternate equipment, inject 20-v rf at 30 MHz, 1-kHz modulation; 8-kHz
deviation.
CONTROL AND SWITCH SETTINGS
POSITION/SETTING
CONTROL OR SWITCH
EQUIPMENT
POWER
ON-RESET
R-442/VRC
BAND
30.00
MC-TUNE-KC
Fully clockwise
VOLUME
NEW OFF
SQUELCH
OPERATE (allow 15-minute warmup)
OPERATE/OFF/STAND BY
AN/URM-103
1000 Hz
FUNCTION
BAND SWITCH
30.00
RF TUNING
10
DEVIATION RANGE KHZ
LO, 0-10 KUV
RF OUTPUT
Fully counterclockwise
DEVIATION
Adjust until needle on IF UV RF SET TO
RF SET TO LINE
LINE meter is over red line
20 v
LO RF UV
POWER
TRACK
AN/USM-207
MIN (fully counterclockwise)
DISPLAY
PLUG IN
SENSITIVITY
FREQ
FUNCTION
104 (black knob)
GATE TIME
DIRECT
DIRECT/HETERODYNE
INPUT
0.3 V MAX (both switches to left)
100
FREQUENCY TUNING-MC
ALINEMENT PROCEDURE
NOTE
Check the frequency counter to make sure that the signal generator is outputting exactly
30 MHz. The rf level must be increased temporarily to enable the frequency counter to
display. Adjust the AN/URM-103 RF TUNING control as necessary, reset to 100-v rf
level; then disconnect the T-connector from the counter.
5-108


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business