Click here to make tpub.com your Home Page

Page Title: A5200 SQUELCH AMPLIFIER ALINEMENT, NEW SQUELCH LEVEL.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



TM 11-5820-401-34-3/0967-LP-432-3060
3-24.
SILICON VERSION A5300A SQUELCH FILTER ALINEMENT. (CONT)
1.
Lift R-442/VRC A3000 tray (1). (See test setup diagram
2.
Set ME-30(*)/U to 10-volt scale.
3.
Connect ME-30(*)/U positive lead to TP5008 (2), and negative lead to ground.
4.
Turn AN/URM-103 DEVIATION control clockwise until DEVIATION KHZ meter indicates
8 kHz.
Adjust AN/URM-127 FREQ RANGE DIAL to vary frequency above and below 150 Hz while
5.
observing ME-30(*)/U. Stop at frequency that gives highest possible ME-30(*)/U
reading.
Check and record the AN/URM-127 modulating frequency as indicated by AN/USM-207
6.
frequency counter. If frequency is 150 1 Hz, A5300A alinement is satisfactory.
If frequency is above 151 Hz, go to step 7; if under 149 Hz, go to step 10.
7.
FREQUENCY ABOVE 151 HZ. Turn R5303 (3) counterclockwise slightly. Reset AN/URM-127
FREQ RANGE DIAL to obtain a peak reading on ME-30(*)/U.
Check frequency on AN/USM-207.
8.
Repeat steps 7 and 8 until peak ME-30(*)/U reading is obtained at a frequency between
9.
149 and 151 Hz.
FREQUENCY BELOW 149 HZ. Turn R5303 (3) clockwise slightly. Reset AN/URM-127 FREQ
10.
RANGE DIAL to obtain a peak reading on ME-30(*)/U.
Check frequency on AN/USM-207.
11.
Repeat steps 10 and 11 until peak ME-30(*)/U reading is obtained at a frequency
12.
between 149 and 151 Hz.
A5200 SQUELCH AMPLIFIER ALINEMENT, NEW SQUELCH LEVEL.
3-25.
PURPOSE. This procedure adjusts the receiver sensitivity to the 150-Hz NEW SQUELCH tone.
TEST EQUIPMENT AND MATERIALS
Matching Unit CN-901/U
Signal Generator AN/URM-103
T-Connector UG-274/U
Frequency Counter AN/USM-207
Loudspeaker LS-454/U
Power Supply PP-1104(*)/G
Voltmeter ME-30(*)/U
Maintenance Kit MK-1978/VRC
TEST SETUP. Connect the eqipment as shown in test setup diagram .
Remove R-442/VRC top
cover. (See paragraph 2-7)
3-118


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business