POWER SWITCH/CIRCUIT BREAKER CB101 REPLACEMENT.

TM 11-5820-401-34-3/0967-LP-432-3060

2-13.

POWER SWITCH/CIRCUIT BREAKER CB101 REPLACEMENT.

MATERIALS/PARTS: Circuit Breaker

PRELIMINARY PROCEDURE: Remove A1000 assembly. (See paragraph 2-9.)

NOTE

At this time S103, J101, J102, PS101, CR101, and CR102 may also be removed.

Removal and installation procedures are obvious.

REMOVAL

1. Using screwdriver, remove two screws (1).

2. Carefully move Connector P101 (2) out of way.

3. Using soldering iron, carefully unsolder red wire (3) from LINE side (4) and white/red wire (5)

from LOAD side (6) of switch (7).

4. Using wrench, remove nut (8) and IT lockwasher (9).

5. Carefully push switch (7) out of panel.

INSTALLATION

1. Position switch (7) in panel and install IT lockwasher(9) and nut (8).

2. Using wrench, tighten nut (8).

3. Using soldering iron, carefully solder red wire (3) to LINE side (4) and white/red wire (5) to

LOAD side (6) of switch (7).

4. Position Connector P101 (2) over holes and install two screws (l).

5. Using screwdriver, tighten two screws (1).

FOLLOW-ON MAINTENANCE: Install A1000 assembly. (See paragraph 2-9.)

2-24