Click here to make tpub.com your Home Page

Page Title: Figure 54. Module A2 parts location.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 



Figure 54. Module A2 parts location.
(2) Adjust the AN/URM-48 frequency
diagrams and to figures 55 and 56 for test
to 30.00 mc and the level to 10
points and parts location.
m i l l i v o l t s as indicated by the
a.Preparation.
(1) Prepare the following equipment:
411A.
(3) Disconnect the 411A from J2 and
(a) Signal Generator AN/URM-48.
connect it between pins 3 and 4 of
(b) Frequency Meter AN/USM-26.
(c) Rf Millivoltmeter 411A.
J1 in the module under test. Note
(d) Adapter UG-274B/U.
the output level.
(4) Compute the gain by subtracting
(e) Multimeter ME-26B/U.
the input db level noted in (2) above
(2) Connect the AN/URM-48 output to
from the output db level noted in
a male connector of the UG-274B/
(3) above. Normal gain is 16 db or
u.
greater.
(3) Connect the AN/USM-26 to the
(5) R e c o n n e c t t h e 4 1 1 A t o t e s t
other male connector of the UG-
point J2 of the m o du 1 e under
274B/U.
test.
(4) Connect the female end of the UG-
(6) Increase the AN/URM-48 level
274B/U to the receiver-transrnit-
until the 411A indicates 20 milli-
ter ANT connector.
volts .
(5) Set the AN/URM-48 frequency to
(7) Repeat the procedure given in (3)
30.00 mc; set the deviation to 10
above.
kc at 1,000 cps.
(8) D e c r e a s e the AN/URM-48 fre-
b. Gain and Bandwidth Test.
quency until the output level indi-
(1) Connect the 411A to J2 of the mod-
cated by the 411A is at the level
ule under test.
110


Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business