|
| TM 11-5820-274-24P
INTRODUCTION
1. Scope
Code
Definition
This manual lists repair parts and special tools
XD A support item that is not stocked. When
required for performance of organizational, direct
required, item will be procured through normal
support, and general support maintenance of the
supply channels.
AN/GSA-7.
NOTE
2. General
Cannibalization or salvage may be used as
a source of supply for any items source
This Repair Parts and Special Tools List is
coded above except those coded XA, XD,
divided into the following sections:
and aircraft support items as restricted by
a. Section II. Repair Parts List. A list of repair
AR 700-42.
parts authorized for use in the performance of
(2) Maintenance code. Maintenance codes are
maintenance. The list also includes parts which
assigned to indicate the levels of maintenance
must be removed for replacement of the
authorized to USE and REPAIR support items.
authorized parts. Parts lists are composed of
The maintenance codes are entered in the third
f u n c t i o n a l groups in ascending numerical
and fourth positions of the Uniform SMR Code
sequence, with the parts in each group, listed in
format as follows:
figure and item number sequence. Bulk materials
(a) The maintenance code entered in the
are listed at end of Section II.
third position will indicate the lower maintenance
b. Section III. Special Tools List. N o t a p -
level authorized to remove, replace, and use the
plicable.
support item. The maintenance code entered in
t h e third position will indicate one of the
Number Index. A list, in ascending National item
following levels of maintenance:
i d e n t i f i c a t i o n number (NIIN, last 9 digits)
sequence, of all National stock numbers appearing
code
Application/Explanation
in the listings, followed by a list, in alphameric
O-Support item is removed, replaced, used at
sequence, of all part numbers appearing in the
the organizational level.
listings. National stock number and part numbers
F-Support item is removed, replaced, used at
are cross-referenced to each illustration figure and
the direct support level.
item number appearance.
(b) The maintenance code entered in the
3. Explanation of Columns
fourth position indicates whether the item is to be
The following provides an explanation of columns
repaired and identifies the lowest maintenance
found in the tabular listings:
level with the capability to perform complete
a. Illustration. This column is divided as
repair (i.e., all authorized maintenance functions).
follows:
This position will contain one of the following
(1) F i g u r e n u m b e r . Indicates the figure
maintenance codes:
number of the illustration in which the item is
code
Application/Explanation
shown.
F - T h e lowest maintenance level capable of
(2) I t e m n u m b e r . T h e n u m b e r u s e d t o
complete repair of the support item is the
identify each item called out in the illustration.
direct support level.
b. Source, Maintenance, and Recoverability
D - T h e lowest maintenance level capable of
Codes (SMR).
complete repair of the support item is the
(1) Source code. Source codes are assigned
depot level.
t o support items to indicate the manner of
Z-Nonreparable. No repair is authorized.
acquiring support items for maintenance, repair,
(3) Recoverability code. Recoverability codes
or overhaul of end items. Source codes are entered
are assigned to support items to indicate the
in the first and second positions of the Uniform
disposition action on unserviceable items. The
SMR Code format as follows:
recoverability code is entered in the fifth position
Code
Definition
of the Uniform SMR Code format as follows:
PA Item procured and stocked for anticipated or
known usage.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |