SECTION I. INTRODUCTION - TM-11-5820-222-34P0005

TM 11 -5820-222-34P

SECTION I

INTRODUCTION

NOTE

1. Scope

Cannibalization or salvage may be used as a

This manual lists spares and repair parts; special tools;

source of supply for any items source coded

pecial test, measurement, and diagnostic equipment

above except those coded XA and aircraft sup-

(TMDE), and other special support equipment required

port items as restricted by AR 700-42.

for performance of direct support, and general support

(2) Maintenance code. Maintenance codes are

maintenance of the AN/VRC-24, AN/VRC-24A,

assigned to indicate the levels of maintenance authorized

AN/TRC-68, and AN/TRC-68A. It authorizes the requi-

to USE and REPAIR support items. The maintenance

sitioning and issue of spares and repair parts as indicated

codes are entered in the third and fourth positions of the

by the source and rnaintenauce codes.

Uniform SMR Code format as follows:

2. General

(a) The maintenance code entered in the third

This Repair Parts and Special Tools List is divided into the

position will indicate the lowest maintenance level

following Sections:

authorized to remove, replace, and use the support item.

a. Section II. Repair Parts List. A list of spares and

The maintenance code entered in the third position will

repair parts authorized for use in the performance of

indicate one of the following levels of maintenance:

maintenance. The list also includes parts which must be

Application/Explanation

Code

removed for replacement of the authorized parts. Parts

O --Support item is removed, replaced, used at the

lists are composed of functional groups in numeric se-

organizational level.

quence, with the parts in each group listed in figure and

F --Support item is removed, replaced, used at the

item number sequence.

direct support level.

b. Section III. Special Tool List. Not applicable.

H --Support item is removed, replaced, used at the

c. Section IV. National Stock Number and Part Num-

general support level.

ber Index. A list, in National item identification number

D --Support items that are removed, replaced, used at

(NIIN) sequence, of all National stock numbers (NSN)

depot, mobile depot, specialized repair activity

appearing in the listings, followed by a list, in alphameric

only.

sequence, of all part numbers appearing in the listings.

(b) The maintenance code entered in the fourth

National stock numbers and part numbers are cross-

position indicates whether the item is to be repaired and

-referenced to each illustration figure and item number ap-

identifies the lowest maintenance level with the capability

pearance.

to perform complete repair (i.e., all authorized mainte-

nance functions). This position will contain one of the

3. Explanation of Columns

following maintenance codes:

a. Illustration. This column is divided as follows:

(1) Figure number. Indicates the figure number of

Application/Explanation

Code

F --The lowest maintenance level capable of complete

the illustration on which the item is shown.

repair of the support item is the direct support

(2) Item number. The number used to identify item

level.

called out in the illustration.

b. Source, Maintenance, and Recoverability (SMR)

H --The lowest maintenance level capable of complete

Codes.

repair of the support item is the general support

(1) Source code. Source codes indicate the manner

level.

of acquiring support items for maintenance, repair, or

D --The lowest maintenance level capable of complete

overhaul of end items. Source codes are entered in the

repair of the support item is the depot level.

first and second positions of the Uniform SMR Code for-

Z --Nonreparable. No repair is authorized.

mat as follows

(3) Recoverability code. Recoverability codes are

Definition

Code

PA-Item procured and stocked for anticipated or known

assigned to support items to indicate the disposition action

usage.

on unserviceable items. The recoverability code is entered

PD--Support item, excluding support equipment,

in the fifth position of the Uniform SMR Code format as

procured for initial issue or outfitting and stocked

follows:

Recoverability

only for subsequent or additional initial issues or

Definition

codes

outfittings. Not subject to automatic replenish-

Z --Nonreparable item. When unserviceable, condemn

ment

and dispose at the level indicated in position 3.

XD--A support item that is not stocked. When required,

F --Reparable item. When uneconomically reparable,

item will be procured through normal supply

channels.

condemn and dispose at the direct support level.