TB 9-2320-387-35-8
13-35. Connect P2 connector (66) of cable assembly (68) to "Station-Out" connector on front FFCS/L (31).
13-36. Route cable assembly (68) against support rail (69) and connect P1 connector (72) to "Station-In"
connector (74) on MCS/L (35).
13-37. Connect P1 connector (67) of cable assembly (71) to power connector (61) on MCS/L (35).
13-38. Route cable assembly (71) under and through two access cutouts (27) to upper mounting
surface (28) and connect to A4J2 connector (65) on MT6352/VRC Mount (57).
13-39. Connect P1 connector (76) of cable assembly (73) to "Radio B" connector (75) on MCS/L (35).
13-40. Route cable assembly (73) under and through two access cutouts (27) to upper mounting
surface (28) and connect to A4J4 connector (64) on MT6352/VRC mount (57).
13-41. Connect P1 connector (76) of cable assembly (77) to "Radio A" connector (78) on MCS/L (35).
13-42. Route cable assembly (77) to upper mounting surface (28) and connect to A4J3 connector (63) on
MT6352/VRC mount (57).
13-43. Secure cables (77) and (24) with tie-down strap (70).
13-44. Locate existing hole (60) on upper mounting surface (28) of radio rack (25) and install screw (62)
and washer (58).
13-45. Install clamp (59) on cable assembly (77) and secure with existing screw (62), washer (58),
lockwasher (7) and nut (8).
13-46. Secure cable assembly (68) on support rail (69) with two tiedown straps (70).
NOTE:
Cables, MCS/L and FFCS/L not shown for clarity.
If MT6352/VRC mount is not installed, longer screw is required
for proper thread length engagement of nut.
13-47. Remove existing screw (79) and washer (81) from MT6352/VRC mount (57) and radio rack (25).
13-48. Install screw (80) and existing washer (81) in MT6352/VRC mount (57) and radio rack (25).
13-49. Install clamp (82) on two cables (71) and (73).
13-50. Secure two cables (71) and (73) and clamp (82) on screw (79) with washer (58), lockwasher (7), and
nut (83).
5-96
