TB 9-2320-387-35-7
NOTE
If installing right side antenna cable only, proceed to step 12-22.
12-11.
Route antenna cable (21) to antenna base (30).
12-12.
Attach antenna cable (21) to antenna base (30).
NOTE
Steps 12-13 and 12-14 apply to reflector on side of vehicle.
Reflector not shown.
12-13.
Remove locknut (12) from screw (43) on lower mounting position of reflector. Discard locknut (12).
12-14.
Install clamp (13) on antenna cable (21) and secure to existing screw (43) with locknut (12).
NOTE
Steps 12-15 and 12-16 apply to reflector on rear of vehicle.
12-15.
Remove locknut (12) from screw (42) on lower mounting position of reflector (41). Discard locknut (12).
12-16.
Install clamp (13) on antenna cable (21) and secure to existing screw (42) with locknut (12).
12-17.
Remove five existing screws (31) securing taillight wiring harness (32) and SINCGARS antenna
cable (21) on rear cargo bed support (37).
12-18.
Route antenna cable (21) along existing taillight wiring harness (32) on rear cargo bed support (37) and
secure with five existing loop clamps (33), (34), (35), (36), (38) and existing self-tapping screws (31).
12-19.
Remove two existing screws (31) securing taillight wiring harness (32) on side of body (2) and
D-beam.
12-20.
Route antenna cable (21) along existing taillight wiring harness on left-side bed and D-beam with
two existing loop clamps (39) and (40), and existing self-tapping screws (31).
12-21.
Coil antenna cable (21) and secure to inside of taillight closeout cover with tiedown strap (16).
2
30
~
13
12
31
32 33
43
34
21
35 36
37
16
39 38
40
~
31
31
21
16
12
12. LOCKNUT 271172 QTY. 2
21
13. CLAMP, LOOP MS21333-98 QTY. 1
42 41
16. TIEDOWN STRAP MS3367-1-0 QTY. A/R
13
Figure 5-86.
5-74