|
| TB 9-2320-387-35-5
Section V. ASSEMBLY OF CAB ENCLOSURE PANEL
NOTE
For 12V terminal board installation on models with rifle mount
bracket shown in figure 5-8, perform steps 5-1 through 5-3.
If not installing 12V terminal board, begin with step 5-4.
5-1. Remove lower rifle mount bracket (1) from B-beam. (Refer to TM 9-2320-387-24.)
5-2. Locate, mark, and drill two 0.159-in. diameter holes marked A in lower rifle mount bracket (1), and
install 12V terminal board (4) with two screws (2), lockwashers (3), and nuts (5).
5-3. Install lower rifle mount bracket (1) on B-beam. (Refer to TM 9-2320-387-24.)
2
3
4
5
1.35
1.50
A
1
3.00
A
2. SCREW MS35206-230 QTY. 2
3. LOCKWASHER MS35338-41 QTY. 2
5. NUT MS35649-63 QTY. 2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |