Section XXIII. PAN AND TILT MODULE (PTM) CONTROL ASSEMBLY, CONTROL CABLE ASSEMBLY, AND DCM/PTM INTERCONNECT CABLE INSTALLATION

TB 9-2320-387-35-3

Section XXIII. PAN AND TILT MODULE (PTM) CONTROL ASSEMBLY, CONTROL CABLE ASSEMBLY,

AND DCM/PTM INTERCONNECT CABLE INSTALLATION

23-1. Locate, mark, and drill 1.375-in. hole (1) for control cable seal assembly (2) on tunnel (3).

23-2. Position control cable seal assembly (2) and mark two hole locations (5).

23-3. Drill two 0.391-in. holes in marked locations (5).

23-4. Insert two rivet nuts (4) into tunnel (3).

23-5. Insert DCM connector end of DCM/PTM interconnect cable (6) from transmission compartment

through hole (1) in tunnel (3), through control cable seal assembly (2), and into driver's

compartment.

23-6. For vehicles equipped with FBCB2, route PTM control cable assembly (8) through PTM control

mounting bracket (7).

NOTE

It may be necessary to remove azimuth lock cable adjusting nut to

route cabling.

23-7. Insert two cables (8) and (9) from PTM control mounting bracket (7) through control cable seal

assembly (2).

NOTE

Holes in grommet must be enlarged to allow cables to fit.

23-8. Cut sides of four holes on grommet of control cable seal assembly (2).

23-9. Insert three cables (6), (8), and (9) from PTM control mounting bracket (7) into tunnel hole (1).

23-10. Route three cables (6), (8), and (9) along exhaust pipe (10), body mount (12), and oil filter (11).

Continue routing cables (6), (8), and (9) through engine compartment to A-frame cable guide (14) on

A-frame pillar flange (13) to PTM mount assembly (15).

6.50

2.00

2. CONTROL CABLE SEAL ASSEMBLY 3220908 QTY. 1

4. RIVET NUT 3221004-14 QTY. 2

Figure 5-87.