Attach heat shrink tubing - TB-9-2320-387-35-10072

TB 9-2320-387-35-1

NOTE

Remove terminal board cover before connecting leads, and

reinstall cover after leads are connected.

13-34. Attach heat shrink tubing (74) and two terminal lugs (72) and (79) to power cable negative lead (78)

and power cable positive lead (75). (Refer to TM 9-2320-387-24 for terminal connector repair.)

13-35. Connect power cable positive lead (75) to 24-volt terminal board (81), located on cab enclosure panel

(82), with existing nut (83).

13-36. Connect power cable negative lead (78) to ground strap (80), located on cab enclosure panel (82),

with existing nut (87). Secure leads (75) and (78) together with tiedown strap (76).

72.

TERMINAL LUG 7728780 QTY. 1

74.

SHRINK TUBING MS23053/4-302-0 QTY. A/R

76.

TIEDOWN STRAP MS3367-1-0 QTY. A/R

79.

TERMINAL LUG 7728777 QTY. 1

Figure 5-62.

13-37. Route remaining cables to integrated rack (83) using one loop clamp (85), existing capscrew (88),

lockwasher (87), and washer (86).

13-38. Route cables along bar (89) to top of integrated rack (83) with two tiedown straps (84).

84.

TIEDOWN STRAP MS53367-1-0 QTY. 2

85.

LOOP CLAMP MS21333-104 QTY. 1

87.

LOCKWASHER MS35338-44 QTY. 1

88.

CAPSCREW B1821BH025C088N QTY. 1

Figure 5-63.

Change 1

5-48