Section V. ASSEMBLY OF CAB ENCLOSURE PANEL

TB 9-2320-387-35-1

Section V. ASSEMBLY OF CAB ENCLOSURE PANEL

NOTE

For 12V terminal board installation on models with rifle mount

bracket shown in figure 5-8, perform steps 5-1 through 5-3.

If not installing 12V terminal board, begin with step 5-4.

5-1. Remove lower rifle mount bracket (1) from B-beam. (Refer to TM 9-2320-387-24.)

5-2. Locate, mark, and drill two 0.159-in. diameter holes marked A in lower rifle mount bracket (1), and

install 12V terminal board (4) with two screws (2), lockwashers (3), and nuts (5).

5-3. Install lower rifle mount bracket (1) on B-beam. (Refer to TM 9-2320-387-24.)

1.35

1.50

3.00

2. SCREW MS35206-230 QTY. 2

3. LOCKWASHER MS35338-41 QTY. 2

5. NUT MS35649-63 QTY. 2

Figure 5-8.

5-6