Insert DCM connector end of DCM/PTM interconnect cable

TB 9-2320-280-35-7

30-5. Insert DCM connector end of DCM/PTM interconnect cable (6) from transmission compartment

through hole (1) in tunnel (3), through control cable seal assembly (2) and into

driver's compartment.

30-6. For vehicles equipped with FBCB2, route PTM control cable assembly (8) through PTM control

mounting bracket (7).

NOTE

It may be necessary to remove azimuth lock cable adjusting nut to

route cabling.

30-7. Insert two cables (8) and (9) though control cable seal assembly (2) through control cable seal

assembly (2).

NOTE

Holes in grommet must be enlarged to allow cables to fit.

30-8. Cut sides of four holes on grommet of control cable seal assembly (2).

30-9. Insert three cables (6), (8), and (9) through control cable seal assembly (2) into tunnel hole (1).

30-10. Route three cables (6), (8), and (9) along exhaust pipe (10), body mount (12), and oil filter (11).

Continue routing cables (6), (8), and (9) through engine compartment to A-frame cable guide (14) on

A-frame pillar flange (13) to PTM mount assembly (15).

5-76