|
| TB 9-2320-280-35-7
PREPARATION FOR INSTALLATION
Section I. PREPARATION OF VEHICLE
Ensure that the site includes adequate lighting and a power source when drilling is required. Inspect the
vehicle for damage that could affect installation. Have any such damage repaired before installing the
C4ISR equipment.
Section II. ITEMS TO BE REMOVED
2-1. Remove batteries. (Refer to TM 9-2320-280-20.)
2-2. Remove right-hand rear cab enclosure panel. (Refer to TM 9-2320-280-20.)
2-3. Remove insulation floorboard. (Refer to TM 9-2320-280-20.)
2-4. Remove standard radio rack. (Refer to TM 9-2320-280-20.)
2-5. Remove D-rings. (Refer to TM 9-2320-280-20.)
Section III. LIST OF ITEMS TO BE RETAINED
3-1. Batteries.
3-2. Right-hand rear cab enclosure panel (if applicable).
Section IV. PREPARATION OF C4ISR EQUIPMENT
Unpack, inspect, and check inventory.
Section V. PRECAUTIONS DURING HANDLING
Observe the following precautions to prevent equipment damage.
a. Keep dust covers in place on connectors.
b. Do not disassemble or modify parts in the C4ISR equipment unless authorized to do so.
c. Keep mounting hardware covered and protected until needed.
Section VI. UNPACK AND INSPECT EQUIPMENT
6-1. Unpack and inspect packaging for evidence of damage.
6-2. Report any shipping damage on SF 364 Report of Discrepancy (ROD) as prescribed in
AR 735-11-2/DLAR 4140.55/NAVMATINST 4355.73A/AFR 400-64/MCO 4430.F.
Section VII. INVENTORY C4ISR EQUIPMENT
If any item is missing, fill out and forward Transportation Discrepancy Report (TDR) (SF 361) as described
in AR 55-38/NAVSUPINST 4610.33C/AFR 75-18/MCO P4610.19D/DLAR 450015.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |