Section XIX. EPLRS CABLES INSTALLATION

TB 9-2320-280-35-6

Section XIX. EPLRS CABLES INSTALLATION

NOTE

Lay out all cables in their approximate positions before clamps are

installed. This will minimize their length and ensure slack is

taken out of all cables from front of vehicle to rear.

Excess slack in all cables will be stored under EPLRS mount

assembly.

19-1. Drill one 0.147-in. hole (6) in right rear wheelhouse (7) between EPLRS mount assembly (1) and

19-2. Connect antenna cable (2) to antenna (4) and route cable behind EPLRS mount assembly (1),

leaving enough cable length to connect to opposite side of EPLRS unit. Coil excess cable (8) and

store under mount assembly (1).

19-3. Secure antenna cable (2) to wheelhouse (7) with loop clamp (5) and self-tapping screw (3).

2. EPLRS ANTENNA CABLE SM-C-911480 QTY. 1

3. SELF-TAPPING SCREW 9421073 QTY. 1

5. CLAMP, LOOP MS21333-69 QTY. 1

Figure 5-54.