Section XIV. PLGR BRACKET INSTALLATION

TB 9-2320-280-35-6

Section XIV. PLGR BRACKET INSTALLATION

14-1. Install PLGR bracket (11) on integrated rack (1) with four screws (12).

14-2. Locate, mark, and drill one 0.201-in. diameter hole (9) in right-side engine tunnel (10).

14-3. Remove paint from vicinity of hole (8) on integrated rack (1) and hole (9) on right-side engine

tunnel (10). Apply anti-seize compound as required.

14-4. Fabricate ground strap (5) from 8.00-in. length of braided wire and two terminal lugs.

14-5. Install ground strap (5) on integrated rack (1) with capscrew (6), two lockwashers (4),

lockwasher (2), and nut (3).

14-6. Install ground strap (5) on right-side engine tunnel (10) with self-tapping screw (7) and two

LOCKWASHER MS35338-44 QTY. 1

NUT 9419143 QTY. 1

LOCKWASHER MS45904-68 QTY. 4

GROUND STRAP

BRAIDED WIRE AA59569F30T0375 QTY. A/R

TERMINAL LUG MS20659-129 QTY. 2

CAPSCREW B1821BH025C100N QTY. 1

SELF-TAPPING SCREW 9426241 QTY. 1

11.

PLGR BRACKET 986-0645-001 QTY. 1

12.

SCREW MS35206-263 QTY. 4

Figure 5-40.