 |
|||
|
|
|||
|
Page Title:
Section XXI. ANTENNA CABLE INSTALLATION |
|
||
| ||||||||||
|
|  TB 9-2320-280-35-4
Section XXI. ANTENNA CABLE INSTALLATION
NOTE
This procedure applies to vehicles without existing antennas. For
vehicles with existing antennas, remove all control cables. (Refer
to TM 9-2320-280-20.)
21-1. Attach antenna cable (15) to antenna base (17).
21-2. Route antenna cable (15) from antenna base (17) with loop clamp (8), existing nut (11),
existing lockwasher (10), existing washer (9) and existing screw (7).
21-3. Route antenna cable (15) along taillight wiring harness with two existing loop clamps (16) and (14),
self-tapping screws (6), and lockwashers (13).
21-4. Route antenna cable (15) along rear (19), intermediate (20), and front (21) cargo bed supports and
along front wheelwell seam (2). Secure with two self-tapping screws (5), loop clamps (3), screw (4),
loop clamp (3), nut (1), and existing self-tapping screw (6) and clamp (18).
21-5. Route antenna cable through right wheelwell/utility area and secure with existing clamp, grommet,
retainer, screws, and plain-assembled nuts. (Refer to TM 9-2320-280-20.)
21-6. Coil excess antenna cable (15) and secure to inside of taillight closeout cover with tiedown
strap (12).
1.
NUT MS35650-302 QTY. 1
3.
LOOP CLAMP MS21333-69 QTY. 3
4.
SCREW MS35224-65 QTY. 1
5.
SELF-TAPPING SCREW 9421073 QTY. 2
8.
LOOP CLAMP MS21333-98 QTY. 1
12.
TIEDOWN STRAP MS3367-1-0 QTY. A/R
1
21
3
20
2
3
3
19
18
17
16
4
15
8
5
13
6
14
12
13
10 9
11
6
7
6
Figure 5-59.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals