Figure 5-52.

TB 9-2320-280-35-4

19-18. Locate, mark, and drill 0.147-in. hole (35) in top of windshield frame (30).

19-19. Route PLGR antenna cable (9) on top of windshield frame (30) and secure with loop clamp (26) and

self-tapping screw (25).

19-20. Route PLGR antenna cable (9) down through center access hole (29) of integrated rack (31), and coil

excess antenna cable (9) under integrated rack (31).

19-21. Route PLGR power cable (33) from PLGR bracket (32) to right side tunnel

insulation (34).

NOTE

Loosen right side tunnel insulation before performing step 19-22.

(Refer to TM 9-2320-280-20.)

19-22. Route PLGR power cable (33) under edge of right side tunnel insulation (34) to 24V terminal bar at

cab enclosure panel.

25. SELF-TAPPING SCREW 9421073 QTY. 1

26. LOOP CLAMP MS21333-65 QTY. 1

33. PLGR POWER CABLE 9728558-10 QTY. 1

Figure 5-52.

5-38