|
| TB 9-2320-280-35-2
NOTE
SINCGARS model AN/VRC-92F shown.
10-8. Install ramball mount (26) on integrated rack (7) with two screws (25), screw (3), lockwasher (1),
lanyard (18), washer (29), three lockwashers (1), and nuts (28).
10-9. Install display isolation kit (22) on display lock assembly (21) with four bolts (30), spacers (19),
lanyard (18), and four wingnuts (20).
10-10. Install display unit (24) on display isolation kit (22) with four screws (23).
10-11. Install display lock assembly (21) on ramball mount (26).
10-12. Fabricate display ground strap (27) from 8-in. length of braided wire and two terminal lugs.
NOTE
Remove paint from vicinity of integrated rack mounting hole
before performing step 10-13. Apply antiseize compound as
required. Ground strap will be installed on integrated rack only
when integrated rack is fully secured in vehicle.
10-13. Install display ground strap (27) on display ground stud (33) with existing lockwasher (32) and
wingnut (31).
20
19
21
18
22
30
33
32
27
31
23
24
3
25
1
26
29
1.
LOCKWASHER MS35338-44 QTY. 4
3.
CAPSCREW B1821BH025C100N QTY. 1
27
7
18.
LANYARD 8925T5-7X19 QTY. 1
19.
SPACER 10705AL315C QTY. 4
20.
WINGNUT MS51553-420 QTY. 4
21.
DISPLAY LOCK ASSEMBLY 872843-1 QTY. 1
22.
DISPLAY ISOLATION KIT 872870-1 QTY. 1
24.
DISPLAY 881293-1 QTY. 1
25.
SCREW MS35190-291 QTY. 2
26.
RAMBALL MOUNT RAM-D-111U QTY. 1
27.
DISPLAY GROUND STRAP
1
BRAIDED WIRE AA59569F30T0375 QTY. A/R
TERMINAL LUG MS20659-141 QTY. 2
28
28. NUT MS35649-2252 QTY. 3
29. WASHER 2436161 QTY. 1
30. BOLT MS35751-18 QTY. 4
Figure 5-27.
Change 1
5-18.1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |