Route SINCGARS antenna cable - TB-9-2320-280-35-130097

TB 9-2320-280-35-13

22-7. Route SINCGARS antenna cable (11) down B-pillar (19) to cab enclosure panel (23).

22-8. Locate, mark, and drill one 0.281-in. hole (27) in right overcab mount (2).

22-9. Secure right-side SINCGARS antenna cable (11) to overcab mount (2) with clamp (28),

screw (29), and nut (26).

NOTE

Clamps will be large to accommodate speaker cables installed in

Section XXIX.

22-10. Secure SINCGARS antenna cable to B-pillar (19) with three clamps (20) and existing screws (21).

22-11. Secure SINCGARS antenna cable (11) to cab enclosure panel (23) with three clamps (22) and

existing screws (29).

22-12. Route SINCGARS antenna cable (11) under integrated rack (25), up through access hole, and to

vicinity of SINCGARS mount.

20.

LOOP CLAMP MS21333-112 QTY. 3

22.

LOOP CLAMP MS21333-69 QTY. 3

26.

NUT 9419143 QTY. 1

28.

LOOP CLAMP MS21333-98 QTY. 1

29.

CAPSCREW B1821BH025C075N QTY. 1

Figure 5-89.

5-69