 |
|||
|
|
|||
|
Page Title:
Section XIII. ANTENNA BRACKET AND ANTENNA INSTALLATION |
|
||
| ||||||||||
|
|  TB 9-2320-280-35-13
Section XIII. ANTENNA BRACKET AND ANTENNA INSTALLATION
NOTE
Do not tighten screws at this time.
13-1. Attach antenna mount (5) to rear wall of right rear wheelhouse (3) with three capscrews (6),
six lockwashers (2), three aluminum spacers (4), and nuts (1).
13-2. Temporarily install support bar (7) on antenna mounting bracket (5).
13-3. Using support bar (7) as template, locate and mark two hole locations (8). Remove support bar (7).
13-4. Drill two 0.281-in. diameter holes (8) in right rear wheelhouse (3).
NOTE
Do not tighten bolts at this time.
13-5. Attach support bar (7) to antenna support bracket with two capscrews (13), lockwashers (10), and
washers (11).
NOTE
Do not tighten capscrews at this time.
13-6. Attach support bar (7) to right rear wheelhouse (3) with two capscrews (12), washers (11),
spacers (4), lockwashers (10), and nuts (9).
13-7. Tighten top two capscrews (6) securing antenna mounting bracket (5) to right rear wheelhouse (3).
13-8. Tighten two capscrews (13) securing support bar (7) to antenna mounting bracket (5).
13-9. Tighten two capscrews (12) securing support bar (7) to right rear wheelhouse (3).
1
2
3
5
4
2
6
1.
NUT 9418892 QTY. 3
2.
LOCKWASHER MS45904-72 QTY. 6
4.
SPACER 10181-5214-01 QTY. 3
5.
BRACKET, ANTENNA BASE RF292 QTY. 1
6.
CAPSCREW B1821BH031F125N QTY. 3
Figure 5-45.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals