Section XXIX. DVE POWER CABLE INSTALLATION

TB 9-2320-280-35-1

Section XXIX. DVE POWER CABLE INSTALLATION

NOTE

Previously routed cables have been removed for clarity.

29-1. Route DVE power cable (2) from DCM mount (1) to center of windshield center support (15), along

plenum (9), and under tunnel insulation (14) to rear of battery box.

29-2. Attach shrink tubing (22) and two terminal lugs (21) and (25) to DVE power cable negative

lead (24) and DVE power cable positive lead (23). (Refer to TM 9-2320-280-20 for terminal connector

repair.)

29-3. Attach DVE power cable positive lead (23) to 24V terminal board (27) with existing nut (20).

29-4. Attach DVE power cable negative lead (24) to ground strap (26) with existing nut (28).

29-5. Secure all leads together with tiedown strap (8).

29-6. Remove two existing screws, lockwasher, and washers from DCM mount (1) and windshield

frame (7).

29-7. Secure two cables (2) and (18) to windshield frame (7) with clamp (19) and screw (17).

29-8. Secure DCM mount (1) to windshield frame (7) with existing washers, lockwashers, and nuts.

29-9. If required, locate, mark, and drill 0.147-in. diameter hole (3) in windshield frame (7).

29-10. Secure two cables (2) and (18) to windshield frame (7) with clamp (16) and screw (17).

29-11. Remove screw (5) and clamp (6) from windshield wiper bracket (4).

29-12. Secure two cables (2) and (18) to windshield wiper bracket (4) with existing clamp (6) and existing

screw (5).

29-13. Secure two cables (2) and (18) to existing cables with tiedown straps (8).

29-14. Secure cabling to plenum (9) with clamps (11) and self-tapping screws (12).

29-15. Install right side tunnel insulation. (Refer to TM 9-2320-280-20.)

29-16. Install batteries. (Refer to TM 9-2320-280-20.)