|
| TB 9-2320-280-35-1
Section XXVI. PAN AND TILT MODULE (PTM) CONTROL MOUNTING BRACKET INSTALLATION
NOTE
Ensure SINCGARS mounting tray is installed. (Refer to chapter 5,
section VIII.)
26-1. Install PTM upper control mount plate (3a) on SINCGARS mounting tray (6), ensuring clamps (4)
on upper portion of PTM control mount plate (3a) engage lower lip (5) of SINCGARS mounting
tray (5).
26-2. Secure upper portion of PTM control mount plate (3a) to SINCGARS mounting tray (6) with three
screws (2) and washers (1). Do not tighten screws (2).
26-3. Install lower portion of PTM control mount plate (3b) to left leg (10) of radio rack (9) with
clamp (7), two screws (11), four washers (1), and two locknuts (8).
26-4. Secure PTM upper control mount plate (3a) to PTM lower control mount plate (3b) with two
screws (11), four washers (1), and two locknuts (8).
26-5. Tighten all locknuts (8) and screws (2).
3a
2
1
4
1
5
6
11
7
1
1
3b
8
9
1
8
10
3. PTM CONTROL MOUNTING ASSY. 3220919-1 QTY. 1
Figure 5-88.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |