|
| TB 9-2320-280-35-1
Section XXI. PLGR ANTENNA AND CABLE INSTALLATION WITH MTS
(WITHOUT BOLT-ON ARMOR)
NOTE
Perform this procedure only when installing additional PLGR
antenna when MTS is installed.
Drilled holes on inside and outside of windshield frame should be
in alignment with each other to allow routing of PLGR cable
through windshield frame.
Relocate all caution labels as necessary.
21-1. Using PLGR antenna mount bracket as template, locate, mark, and drill two 0.50-in. holes (3) in
outer windshield frame (1).
21-2. Locate, mark, and drill 0.375-in. diameter hole (2) in outer windshield frame (1).
2
1
3
3
0.75
3.00
Figure 5-67.
21-3. Locate, mark, and drill 0.375-in. diameter hole (4) in left side inner windshield frame (5).
4
5
1.25
~
5.12
Figure 5-68.
Change 1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |