|
| |
TM 11-5820-890-30-5
15-20. REPLACEMENT OF MOUNTING PLATE ASSEMBLY.
Tools:
Flat tip screwdriver
Torque screwdriver
Flat tip adapter
References:
Paragraph 15-35 for removal and installation of threaded screw inserts.
ITEM
ACTION
REMARKS
REMOVAL
a. Battery tray assembly
b. Eight captive screws (4)
and flat washers (5)
c. Battery tray
subassembly (1)
d. Battery tray gasket (3)
e. Mounting plate
assembly (2)
INSTALLATION
f. Mounting plate
assembly (2)
g. Battery tray gasket (3)
h. Mounting plate assembly
(2) and battery tray
subassembly (1)
i. Eight captive
screws (4) and flat
washers (5)
Set upside down on work surface with
left side toward you. See figure 15-4.
Use flat tip screwdriver. Fully loosen
and inspect eight captive screws and
flat washers securing mounting plate
assembly (2) to battery tray subassem-
bly (1). If damaged, obtain replacement.
Remove and retain.
Check for damage.
Remove and discard.
Obtain replacement mounting plate
assembly.
Position to replacement mounting
plate assembly.
Position replacement mounting plate
assembly (2) to retained battery tray
subassembly (1).
Use torque screwdriver and flat tip adapt- Inspect each screw and its
er. Install eight captive screws and flat
threaded screw insert to
washers securing replacement mounting
determine if any is defec-
plate assembly (2) to retained battery
tive. If a screw is not
tray subassembly (1). Torque screws to
stripped but will not tighten,
9 in-lb.
refer to paragraph 15-35
for removal and replace-
ment of threaded screw
inserts.
15-22
|
