|
| |
TM 11-5820-890-30-5
13-11. REPLACEMENT OF AUDIO CONNECTOR. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
d. Wires
INSTALLATION
e. Wires
f. Connector insert
g. Connector shell
h. Two set screws
Note each wire position. Using soldering
kit, desolder wires from connector insert.
Using soldering kit, solder wires to correct
Before and after soldering,
positions on connector insert.
clean solder joints with
cotton swabs and alcohol.
Aline and install connector insert into
connector shell.
Hold connector shell and cable “in-place”
and use slip-joint pliers to turn connector
adapter nut until connector shell is tight
against connector adapter nut.
Using a hex head key install and tighten
two set screws in connector adapter nut.
Ensure connector adapter nut has only
90 degree turning radius in either direction
Section V. PREPARATION FOR STORAGE OR SHIPMENT
13-12. GENERAL INFORMATION.
Pack the CX-13293/VRC cable in an approved shipping container.
13-7
|
