|
| |
TM 11-5820-890-30-5
Section IV.
Subject
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . .
Operational Check . . . . . . . . . . . . . . . . . . . .
Repair Procedure . . . . . . . . . . . . . . . . . . . . .
Replacement Of Audio Connector . . . . . . .
13-8. INTRODUCTION.
MAINTENANCE PROCEDURES
Para
Page
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13-8
13-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13-9
13-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13-10
13-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13-11
13-6
Maintenance of the CX-13293/VRC cable consists of checking by inspection and repair of the audio connector.
All other components are to be sent to general support for repair.
13-9. OPERATIONAL CHECK.
Perform the operational check found in paragraph 13-6 to verify the proper operation of the CX-13293/VRC
cable.
13-10. REPAIR PROCEDURE.
With the exception of the audio connector, the CX-13293/VRC cable is a non-repairable item and when found to
be defective should be disposed-of in an appropriate manner. The procedure for replacement of the audio
connector is found in the following paragraph.
13-11. REPLACEMENT OF AUDIO CONNECTOR.
Tools:
Hex Head Key
Slip-Joint Pliers
Soldering kit
Expendable supplies:
Alcohol
Cotton swabs
Soldering kit
NOTE:
If connector shell is damaged and shell insert is undamaged, replace only shell. Do not replace
insert unless damaged.
ITEM
ACTION
REMARKS
REMOVAL
a. Two set screws
b. Connector shell
Using hex head key, loosen and remove
two set screws in connector adapter nut.
Hold connector shell and cable “in-place”
and use slip-joint pliers to turn connector
adapter nut until connector shell is free
of cable assembly.
c. Connector insert
Carefully remove connector insert from
connector shell and discard defective
connector shell.
13-6
|
