|
| |
TM 11-5820-890-30-5
3-26. REPLACEMENT OF CONNECTORS.
Tools:
Socket wrench
Cross tip screwdriver, #1 point
Soldering kit
7/32-inch nutdriver
3/4-inch spanner wrench
1/2-inch socket
Pin insertion/removal tool
Expendable supplies:
Alcohol
Cotton swabs
Solder
References:
Paragraph 3-25 for removal and installation of test adapter from maintenance group lid.
Figure 3-12 for location of connectors.
a. Replacement of Front Panel Mounted BNC Connectors (J1, J2, J3, J5, J6, J7, J8, and J17).
ITEM
ACTION
REMARKS
REMOVAL
a. Wires
Using soldering kit, desolder wires from
See figure 3-12
connector (6) and ground tab (18).
(sheets 1 and 2).
b. Connector (6)
Using socket wrench and 1/2-inch
socket, remove and retain hex nut (45)
and ground tab (18) securing connector
to test adapter. Remove and discard
connector from test adapter.
INSTALLATION
c. Connector (6)
d. Wires
Insert replacement connector in test
These were removed in
adapter. Install retained ground tab
step b.
(18) and hex nut (45) on connector.
Using socket wrench and 1/2-inch
socket, tighten nut.
Using soldering kit, solder wires to
Before and after soldering,
correct positions on connector and
clean solder joints with
ground tab.
cotton swabs and alcohol.
3-93
|
