|
| |
TM 11-5820-890-30-5
3-26. REPLACEMENT OF CONNECTORS. Continued
b. Replacement of Circular Multipin Connector J11.
ITEM
ACTION
REMARKS
REMOVAL
a. Four screws (2), nuts (5),
flat washers (4), and
spacers (2A)
b. Wires and pins
INSTALLATION
c. Pins
d. Connector (3)
e. Four screws (2), nuts (5),
flat washers (4), and
spacers (2A)
3-94
Using cross tip screwdriver and 7/32-inch
nutdriver, remove and retain four screws,
nuts, flat washers, and spacers securing
connector J11 (3) to test adapter.
Remove connector J11 from test adapter,
Use soldering kit, and pin insertion/removal
tool included in connector package.
Remove any damaged pins from con-
nector (3). Desolder pins from wires
and solder new pins on wires.
Use pin insertion/removal tool. Remove
remaining pins one at a time from bad
connector and install all pins in correct
positions in replacement connector.
Insert connector in test adapter with
correct orientation.
Use cross tip screwdriver and 7/32-inch
nutdriver. Insert four retained screws
through connector and test adapter.
Install and tighten screws with four
retained flat washers, spacers, and
nuts.
See figure 3-12 (sheet 1).
Before and after soldering,
clean solder joints with cot-
ton swabs and alcohol.
These were removed in
step a.
|
