h. Quantity Incorporated in Unit. Indicates the
quantity of the item used in the breakout shown on the
illustration figure, which is prepared for a functional
group, subfunctional group, or an assembly. A "V"
requisitioned for plug-in boards
appearing in this column in lieu of quantity indicates that
identified in the plug-in board
no specific quantity is applicable (e.g., shims, spacers,
exchange program, except by the
depot designated to perform the
Repair of calibration set
4. Special Information
components, with plug-in board
a. Repair parts for components of standards sets
designated as program exchange
which can be identified as existing in the supply system
replacements with a recoverability
will be requisitioned through normal supply channels
code of L, will be accomplished by
from the appropriate supply commodity manager.
replacing the plug-in board.
b. Repair parts for components of standards sets
c. The plug-in board exchange program functions
which cannot be identified as to proper supply source
will be requisitioned from USAMIRCOM, using routing
identifier B64 and furnishing as a minimum, the following
(1) Requisitioning instructions for initial issue
as exception data.
plug-in boards will be provided since new instrument
boards are included in the program.
(1) Component stock number of the individual
end item to be repaired.
(2) As a plug-in board covered by the
program fails, a replacement will be requisitioned.
(2) Component manufacturer's
Requisitions will be submitted to Commander, US Army
model number and serial number.
Missile Readiness Command, B64, Redstone Arsenal,
(3) The equipment manufacturers stock
number as listed in the appropriate manual for the
(3) Simultaneously with c(2) above, the
desired repair part.
defective board being replaced will be shipped by
certified mail, return receipt requested, to the following
(4) The repair part reference designation,
circuit reference, circuit symbol schematic designation,
or reference number as listed in the manufacturer's
Anniston Army Depot
M/F Field Service Stock
(5) The technical specification of the repair
Anniston, AL 36201
part as contained in the appropriate manufacturer's
When requisitioning a replacement board, the turn-in
document number of the replaced board shall be cited
(6) The title and date of the manufacturers
on the requisition.
manual from which the information in paragraphs a, (3),
(4), and (5) above was taken.
5. How to Locate Repair Parts
a. When NSN or reference number is unknown:
Using the table of contents,
determine the assembly (functional group) within which
the repair part belongs.